WFHSS - World Forum for Hospital Sterile Supply

Communications [30/09/2008] Open letter to heads of sterilization departments in countries where there are no national societies
Conferences & Congresses [01/10/2008] Conference Info Update: IASSM Conference 2008 - "Audit aftershock" - 7/8 November 2008 in Dublin-Blanchardstown, Ireland
Courses & Seminars
Questions & Answers [07/10/2008] new question 1946: Statim and eye instruments
Discussion Forum
Industrial Partners
Commercial Announcements
Related Sites & Links
Humour [03/10/2008] new cartoon: Operating Manual
Industrial Partners:


Developed by Baumeister Mediasoft Engineering

WFHSS - World Forum for Hospital Sterile Supply

Central Service - Issue 6/00 - English VersionZentralsterilisation - Ausgabe 6/00 - Deutsche Version


WFHSS - World Forum for Hospital Sterile Supply:: Publications :: Periodicals :: Central Service :: Central Service Archive :: Central Service 6/00
Central Service - Issue 6/00

Central Service - Issue 6/00


New nvCJD Cases in Britain


What's New in Standardisation: Sterilization Wrap
EFHSS: Minutes of the First General Meeting
Sterilisation Section of the DGKH: New Commitee
New UK Department of Health Documents
FDA Guidance on Reusing Single-Use Devices
British Medical Devices Agency: Negative Position on the Reuse of Medical Single-Use Devices
Central Service in Latvia: New Association
Forum 2000: Investigation of Automated Cleaning Performance
VSZ Study Day: The Minutes


M. Pietsch, V. Adrian, H. Haindl, A. Kramer:
Manual and Automated Processing of Tracheal Tubes Made of Silicone.
Microbiological, toxicological and physical studies

Processing of medical devices is subject to quality criteria and is to be defined according to the device. With the help of three different tracheal tubes made of silicone, an investigation was carried out to establish whether important criteria can be complied with after 100 manual or automated cleaning and disinfection cycles followed by steam sterilisation. The microbial reductions achieved by the entire processing procedure (spores of Bacillus subtilis/Bacillus stearothermophilus) in both procedures were between 7.0 - 9.1. Examination of physical parameters merely showed a low-grade reduction of elasticity of the silicone and slight shrinkage of one of the two connector materials examined. Regarding cytotoxicity and the optical impression, however, both processing procedures differed distinctly. Cytotoxic effects and unaesthetic changes in colour occurred in manual processing with an aldehyde agent from the 20th processing cycle onwards and functional problems occurred from the 80th processing cycle onwards, so that this procedure is not justifiable in principle. Occasional changes in colour could be observed in the automated procedure from the 60th cycle onwards, and from the 80th cycle onwards a cytotoxic effect or a functional impairment could be occasionally noticed. This form of processing can therefore be carried out up to 50 times.

T.J.H. Orzechowski, A.C.P. de Bruijn, C. Wassenaar:
Measurement of the Efficacy of Cleaning Procedures for Dental Handpieces.
Evaluation of an Eluation Method

Efficient cleaning is the cornerstone of infection prevention in dental practice. However, the level of the cleanliness to be achieved is a topic of discussion. The cleanliness of the outer surfaces of dental handpieces can be determined, to a degree, by visual inspection. The inner surfaces of these narrow lumen instruments do not allow visual inspection, thus other techniques must be applied. Swab tests are only partly suitable for use with hollow medical instruments, because in most cases it is impossible to swab the inner surfaces of these instruments without fully dismantling them. Even then the very narrow lumen of hollow instruments (e.g. air and water channels of dental handpieces) can never be swabbed.
In this paper a quantitative elution method is evaluated to assess the efficacy of cleaning procedures by measuring the reduction in protein contamination in artificially soiled dental handpieces.
Various process parameters were included in the study e.g. sensitivity and reproducibility With an average soiling of 411 µg/ml and a detection limit of 10 µg/ml the maximum reduction factor given by a cleaning procedure is 41. This equals a 95% reduction of the initial contamination.
The evaluation of the test principle revealed a number of problems that may not be relevant uniquely to dental handpieces, but to all kinds of medical devices of a complex construction.


50 % Time Saving at the Drying Stage of Automated Instrument Cleaning
New Procedure from Dr. Weigert, Hamburg

In automated instrument cleaning processes, the drying stage after the cleaning and thermal disinfection takes up a great deal of time and frequently takes even longer than the whole cleaning and disinfection stage. The drying time is thus mainly responsible that at times in the CSSD processing large quantities of instruments becomes almost impossible to achieve in the available time. With the newly developed rinse-aid neodisher mediklar the drying period can be reduced by 50%.


ENT Instruments/B & D Test


P. Heeg
Infections by Rickettsia, Coxiella and Ehrlichia


Investigating the Disinfection Effect with Thermologgers

Information on this page provided with kind permission of: mhp-verlag GmbH
Address: Marktplatz 13
65183 Wiesbaden
mhp stands for publications in medicine, hygiene and prevention. For more than 20 years, the mhp publishing house has devoted itself to supporting developments aiming for a better standard of hygiene and infection control in hospitals and other medical facilities.
WFHSS - World Forum for Hospital Sterile Supply:: Publications :: Periodicals :: Central Service :: Central Service Archive :: Central Service 6/00

© 2008 WFHSS • Updated: 05 January 2008, 02:58 [GMT]